Might there be a tradesman’s trick for getting aftermarket gaskets to seal properly. I have a fridge that I’m told had this gasket replaced about 5 years ago. Even at that time the gasket fit was as you see it in the attached images. They’ve made no previous attempt to get a better fit. I just looked at it and the installation looks proper — The gasket simply seems like it has no extension (accordion effect) at the two corners.
The poor seal caused much condensation both inside and out. Unfortunately this is taking its toll in the form of minor isolated corrosion (as seen in pic) along with a constant mildew problem. This Kenmore (#2539768481) is probably 12-15 years old and, while still in otherwise very good condition, I’m not sure investing in a $100+ genuine gasket is worth it.
Any tricks-of-the-trade appreciated.